Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur télécharger pdf (Page 38)

Jeppesen Workboat Navigator Installer’s Guide

2 - Installation

STEP 8. Boat Configuration

Individual Boat configuration is adjusted by editing the BoatDef.ini and

Navobj.txt files. This prevents your boat settings from accidentally being edited or

deleted while you are underway.

Tow settings can be edited using the Boat Properties Menu.

To Configure BoatDef.ini Settings

Close all programs

Open the BoatDef.ini file using Notepad, Wordpad or another text editor. (C:\

Program Files\Jeppesen Marine\WorkboatNavigator\Config\Vessel\BoatDef.ini)

Under the [Tow Info] settings, input your Boat ID, boat length, width, air draft,

draft, and port and bow offset.

NOTE:

Most settings in the ini file are total inches, for example 32 ft, 0 in =

384". However, the air draft and draft settings are in total meters.

WARNING

: When you change the Boat ID (boat name), do not use special

characters such as slashes, back-slashes, underscores and hyphens.

Although the name will appear correctly in Workboat Navigator, Voyage Data

files will not be created.

Figure 2.29 - BoatDef.ini file

Save your changes by selecting File | Save or

Close the BoatDef.ini file.

Changes made will be available the next time you start Jeppesen Workboat

Navigator.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

Pas de commentaire

Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur Page 38