Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur télécharger pdf (Page 34)

Jeppesen Workboat Navigator Installer’s Guide

2 - Installation

Configuring for GPS Data

Once you have connected your GPS, you will need to set up your GPS Port Speed

(baud rate) for the COM port connected to the GPS. To configure your GPS COM

Port:

Start Jeppesen Workboat Navigator.

Open System Menu | Tools/Settings | Options | Ports: Configure.

In the Input Ports column, place a check-mark next to the COM Port connected

to your GPS.

With the GPS COM Port highlighted, click Configure This Input Port...

Set the Port Speed (baud rate) to match the baud rate of your GPS device.

(Typically 4800).

Click OK.

Click OK again to close the Options window.

Configuring for Heading Sensor Data

A Heading Sensor can improve the stability of charts with radar overlay and

calculation of target-tracking data.

NOTE:

Heading Sensors and the IR2-BB can be installed and configured

together.

Connect your Heading Sensor to an available serial port on your computer.

Start Jeppesen Workboat Navigator.

Open System Menu | Tools/Settings | Options | Ports: Configure.

In the Input Ports column, place a check-mark next to the COM Port your

Heading Sensor is connected to.

Click on the Heading Sensor COM Port, and then click Configure This Input

Port...

Set the Port Speed (baud rate) to match the baud rate of your Heading Sensor.

Some Heading Sensor model’s baud rate may vary, but 4800 is the standard.

Click OK.

Click OK again to close the Options window.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Pas de commentaire

Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur Page 34