Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur télécharger pdf (Page 33)

2 - Installation

STEP 7. Configure Your COM Ports

Ports: Configure

TIP:

If you select the same COM port for Input and Output, then data can be

received by and transmitted from the COM Port (this is fairly common). This

is required when sending data to the AIS device.

Input Ports: Designates COM ports that will receive data from hardware devices.

Output Ports: Designates COM ports to which data will be sent.

To Configure Input COM Ports

Select System Menu | Tools/Settings | Options | Ports: Configure Tab (Figure

2.24).

In the Input Ports column, check which COM port(s) are in use for each

hardware device connected to your computer.

Figure 2.24 - Settings | Options | Ports: Configure Tab

Select a COM port used by the device you wish to configure, and click

Configure This Input Port... to edit the type of incoming data (Figure 2.25).

Figure 2.25 - COM port Input Configuration

To fine-tune your settings, you may wish to include or remove NMEA sentences

specific to the device connected to each COM Port. Tables 2.2-2.8 in Step 4 list

specific NMEA sentences for each device.

Click OK to save your changes.

From the COM# Input Configuration window, you can include or exclude specific

data sentences or entire device sentence streams. Click on the More Info button for

more examples (Figure 2.25).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

Pas de commentaire

Jeppesen Marine Workboat Navigator 1.3 Manuel d'utilisateur Page 33